Servo setup betaflight | Drone Community | Page 1

bleak spade Apr 15, 2026, 4:49 PM

#

I've wired the servo signal motor to the led pad on my board. In betaflight i set that resource to servo and bound it to aux2. for some reason when i connect the drone to my computer or the battery, the servo starts moving in steps (as if it was an led flashing). it does this until the gears start slipping and making a clicking noise. any ideas how to fix this?

#

i can send a video if needed

spiral gazelle Apr 15, 2026, 6:20 PM

#

Did you do resource led none

bleak spade Apr 15, 2026, 6:26 PM

#

spiral gazelle Did you do ```resource led none```

yep

spiral gazelle Apr 15, 2026, 6:29 PM

#

How did you "bind" it to channel 2

#

Port forwarding?

bleak spade Apr 15, 2026, 7:02 PM

#

turns out i had jt set to channel 2 instead of aux 2 so it was bound to the throttle 😅

#

problem solved it works now

#

whoops lol

spiral gazelle Apr 15, 2026, 7:11 PM

#

Lol

bleak spade Apr 17, 2026, 2:52 PM

#

#Servo setup betaflight