I was flying my new AIR 65 II around my garden when i crashed, i tried to turtle out a little before realising my drone was fully stuck, so i disarmed and took the drone back inside. Now it seems like one motor is not being spun correctly. Im not sure if this is the motor or the ESC.
#AIR 65 intermittent motor
cedar geyser
fossil marsh
did a motor wire fall off
cedar geyser
All 3 pads are still soldered
fossil marsh
on the motor side too?
acutlaly these motors dont have pads on the motor
does the motor start spinning if you try helping it with your finger
like flick it in the right direction when armed
cedar geyser
on the motor side too?
yea both sides still seemingly connected
pushing the motor by hand does not change it
i think its the motor its seemingly getting quite hot
while the ESC temp remains quite low still
ocean briar
There are some pretty good nicks in your props, have you pulled the props off yet to see if any debris is down in there?
cedar geyser
There are some pretty good nicks in your props, have you pulled the props off ye...
nah nothing in there, but the motor bell doesnt seem to be on straight
ocean briar
that is probably the fix, you can gently tweak it back.
ocean briar
There should be a very even gap around the bell, and look pretty uniform around the blades to frame.
