keen tendon
Just building a new quad and motor 4 doesn't spin at all.
Tried 2 usb cable
Tried looking in ESC config.. only 3 ESC show up..
Measured Resistance between motor 4 poles all full continuity
Is the ESC faulty, or what can I do without having to solder off the motors.
nocturne sinew
make sure none of the wires from the cable between the fc and esc have been pushed out of the connector
keen tendon
nocturne sinew
also feel the motor when you plug it in to see if it makes the whole start up sound
keen tendon
Ah yeah tried plugging fc/esc cable in and out. Will check the cable individually
nocturne sinew
you are using the speedy bee fc as well?
nocturne sinew
looks fine
keen tendon
Insulated cable from the cap is touching bottomside of the ESC
nocturne sinew
feel if the motor makes the start up tone
keen tendon
Oke
lilac atlas
Do all the motor controllers show up in blheli suite?
nocturne sinew
Do all the motor controllers show up in blheli suite?
its an 8 bit esc, you use esc configurator. and he said only 3 escs show up
lilac atlas
Hm oke
keen tendon
feel if the motor makes the start up tone
It does
nocturne sinew
just the first part or both?
the first 3 beeps mean the esc powered up, the last 2 means its communicating with the fc
keen tendon
just the first part or both?
Full sequence
nocturne sinew
if you got that then it would work
nocturne sinew
the other motors will make that sound
you need to hold that motor and feel if it does
keen tendon
you need to hold that motor and feel if it does
Yeah I did before, it does. I just don't have enough hands to film 😂
3 beeps and 2
keen tendon
and esc config reads only 3?
When you make a photo it says 4 🦧🙈🙈🙈
Should I flash them while i'm at it./?
nocturne sinew
i guess you could try flash to bluejay
nocturne sinew
blhelis
