#Drone not spinning right...
150 messages · Page 1 of 1 (latest)
yea it doesnt connect
could you show that?
and you can't click on the green connect button?
No
do that first
read setup bottom right corner
Stupid thing
for all of the ESCs on the right side, change the motor direction to the opposite of what is set now
Now it won’t let me go back into the thing
the thing?
Back into where I can control the motors
It just won’t let me go back into that menu when I click connect
well you have to make your changes, click write setup, and then it should disconnect or go back to that
It says port already in use by another application
that would be betaflight
I don’t have beta flight even on
Now it won’t let me go into beta flight
Ima restart my pc rq
did you disconnect from the ESC configurator first?
before connecting to betaflight?
multiple tabs of the ESC configurator would also probably not work
Dude what is happening
It’s not working man
@honest thicket
It’s not letting me go into betaflight anymore
Idk what to do at this point
I can even connect to betaflight
@honest thicket
U still here man
?
oh yeah sorry @wet bane
Alr
still not working?
try closing betaflight, disconnecting drone from everything
closing esc configurator
and reopening everything
you can / should turn off the radio yeah
try again to connect, then click on "read setup" in the bottom right corner
hold on you don't need to flash firmware
Wait ok
to reverse the direction you can just change the direction using the dropdown and then click "write setup" in the bottom right
yeah
weird that only two showed up though
you can try the things it says down there which are turning off radio and clicking read setup again
U sure?
yes
Do I disconnect and go through it again
you don't have to disconnect
just turn off radio if it is on and click read setup
do you have the battery plugged into the quad?
It just keeps getting failed readings idk what’s the problem with this thing
Yes
Now there’s no esc
It’s trying to read 4 and they are all failing
strange
Ima try disconnecting
is your battery good on charge still?
I’m wondering does the yeast
Zdag
Thing do anything
Zadig
I rewrote a while back someof the bulk to winding
Winusb”
I wouldn't think this is a USB issue
well the fact that you saw two escs then one then none kind of sounds like there isn't enough power getting to the escs
which is why I asked about the battery
Lemme change it tour
Out
It’s reading them
Right now
It’s reading the first one well
Failed reading esc2
I have my goggles on?
Would that be a problem?
@honest thicket
no that's not a problem
Now nothings working 😡
So idk what to do at this point
I’m tired
Can we do this tommorow?
Idk at this point should I just buy a new drone?
Cause idk the problem
worst case just swap the props it's not all over 😆
but yeah it is pretty late
when you work on this again now you know what you have to do
which is reverse the motor directions
(or swap the props)
Cause idk how to even take the props off
you'll figure it out
These stupid things have such a tight grip on the motor
I looked at videos
I don’t have the tools
the tools make it a lot easier but you can take them off by hand
I've never seen a video about this but I just searched for "how to take off tiny whoop props" and there seem to be a lot
a lot with tweezers
but like I said you can try with your hands first
Should I just pop em all of off and swap them
Cause idk how I’m gonna know if I have them the opposite way
just swap them left / right
I just flip them upside down and pop them back on?