quaint arch
I finally got to the last final steps of getting my quad to run but I’ve run into an issue. I am getting a video output but no picture. I’ve made sure smartaudio was enabled on port 5 and I used a multimeter to make sure the camera was getting 5V at the connector. It is a rushfpv Solo tank and a ratel mini luminier edition.
alpine sand
Various stuff to try:
Wire cam output to VTX input directly.
To remove the FC as a possible issue for troubleshooting.
[Probably try this one last even tho I listed it first.]
Since your VTX is getting OSD, this is unlikely to be the problem. Its just a common troubleshooting step.
Try a different camera if u got one handy or can borrow one from another nearby pilot.
Double check the cam doesn't have a lens cap on.
Disassemble the cam and see its image sensor it or the lens seems damaged or blocked.
quaint arch
Various stuff to try:
Wire cam output to VTX input directly.
To remove the FC ...
definitely doesn’t have a cap on and the sensor looks fine. I’m going to try to wire the camera directly tomorrow if that doesn’t work I’ll buy a new camera.
verbal oasis
Right away to me this looks like a camera power issue
Or video signal from the camera to FC is not working
quaint arch
Right away to me this looks like a camera power issue
camera is definitely getting power i tested it with a multimeter from the connector and i connected the camera directly to the vtx and got no signal so i’m thinking bad camera