#binding crux35
35 messages · Page 1 of 1 (latest)
Do you know if the onboard receiver is connected over SPI or UART?
I'm not sure. How did I tell?
Can you take photos of the box?
UART
Sick
Power it on for 60s and a wifi access point called ExpressLRS RX should be available on your pc/laptop/phone
Connect to that access point with the password expresslrs, and navigate to http://10.0.0.1
Then get a screenshot of that page and send it here
Sure
@lofty jackal
Sorry, could you get the top part of the page as well?
That was nothing in what I cropped off but sure
There is very important info in the header of the page
Is that it?
yes, that is the important bit we needed to know
if you go to the ELRS lua script on the radio and enable the transmitter module wifi, you will be able to connect to it much the same as the receiver
get a screenshot of that page too
incl the header
Can I not do the standard bind option?
You might consider upgrading the firmware on the RX, it's quite old.
But power cycle the quad 3 times to put the RX into bind mode. Load the ELRS LUA script on the radio and press "bind".
you should be able to bind them without changing the firmware, just set both to the same bind phrase, it can be pretty much anything
Got it to bind. Thank you
My controls are swapped so my throttle is being controlled by my right stick
How do I fix this again?
In this video i show you how to invert fpv controls in betaflight... Not alot of info can be found online about this or its not streamlined enough so i hope this helps somebody... good vibes.... Please like and subscribe videos will keep coming. Good Vibes!
Might want to try this
Uhm or its a setting in betaflight cheack that out first
Thank you just figured it out 5 min before you sent it. Thanks tho