Bought 2 and both had the same issue. Im connecting the flight controller and esc to a pdb which is connected to a DC alternating power supply for testing.
#Ruibet 45A 4in1 ESC M1 and M2 doesnt work or isnt recognized but M3 and M4 motors seem to work fine.
gloomy kite
hard idol
Bought 2 and both had the same issue. Im connecting the flight controller and es...
did you check the connection between the FC and ESC?
bent pins in plugs, etc
gloomy kite
did you check the connection between the FC and ESC?
i used the 8 pin cable to connect instead of solder. Is this a common issue? The motors are soldered directly to the ESC
hard idol
i used the 8 pin cable to connect instead of solder. Is this a common issue? The...
Sometimes pins get bent in the connector. It's not common, but it happens to someone from time to time.
All you gotta do is inplug the cable and look inside the connectors..
take pics if unsure
gloomy kite
Sometimes pins get bent in the connector. It's not common, but it happens to som...
Ah ok, they dont seem to be bent on the esc or the fc. I also tried with different 8 pin connectors too but ran into the same issue
hard idol
Ah ok, they dont seem to be bent on the esc or the fc. I also tried with differe...
how could you try with different 8pin connectors?
they're fixed to the FC and ESC
gloomy kite
how could you try with different 8pin connectors?
Oh i meant the 8 pin cables. I received three, one from the FC and two from the original and replacement ESCs
hard idol
the cable is irrelevant
it's the pins in the connector of the FC and ESC that I want you to check
gloomy kite
For the FC, i updated it to 4.4.3. The ESC hasnt been updated yet, since it'll only be able to see and update the 2 ESCs recognized
hard idol
For the FC, i updated it to 4.4.3. The ESC hasnt been updated yet, since it'll o...
For the FC, i updated it to 4.4.3
did it work before updating?
gloomy kite
No, it never worked, only ran the two ESCs