Setting up multiple LED's using 1 LED pad

[cerulean terrace]

On the FC I am using (Hobbywing F7 Convertible), there is only 1 LED pad, however, I would like to use 4 of the tiny's LEDs Saddle Lights (https://tinysleds.com/products/saddlelites?_pos=1&_sid=0e631b585&_ss=r&variant=14394634108983). I found this image on the Oscar Liang website but the Saddle Lights do not have a way to easily connect them to each other. Is there another/easier way to set up the saddle lights? Thanks.

[icy dome]

Solder 4 signal wires from those boards to the one pad

If possible

[cerulean terrace]

i will try

is there any good way to solder 4 wires to 1 pad?

[icy dome]

Enough solder, flux, and temperature

You can also make a little splitter out of some wire, but you'd need to insulate it

[cerulean terrace]

so would I stack them on top of each other?

[icy dome]

Not on top, more like from different angles

[cerulean terrace]

i see

so usually I cut the exposed wire to the size of the pad but in this case should I cut them shorter to fit them all on the pad?

[icy dome]

Yea