AxisFlying Manta 5" Testing rig | Drone Community | Page 1

tribal flame Nov 14, 2023, 8:50 PM

#

Gonna log the build here while I'm at it

#

I liked the yellow of the Speedybee Master 5 v2 frame, but other than that the Manta is much nicer. So I got some custom prints out of a very nice yellow TPU

#

First fit and color check

#

All parts lightly put in place to get a feel for the finished thing, I'll solder it tomorrow or overmorrow, I don't have that kinda trust in 10pm me

#

@pliant echo Manta build post here 😄

#

I like all the little details... Bottom screw protectors, even found a remaining bit of sleeving to put over the positive wire of the xt60

#

Yellow spacers from the speedybee stack

#

(I may even re-pin the VTX wire to remove the green wire KEKw )

#

It almost looks edible

#

Next build is gonna be red hopefully

pallid zealot Nov 14, 2023, 9:14 PM

#

hot

#

that better not be what I think it is tho

tribal flame Nov 14, 2023, 9:27 PM

#

pallid zealot that better not be what I think it is tho

It is and that's why it's there

#

Un!t tested it without issue

#

I need a proper way to test it too, I really want it to be decent enough so that I can stop screaming at people not to get the V3 KEKw

pliant echo Nov 15, 2023, 10:01 AM

#

tribal flame I need a proper way to test it too, I really want it to be decent enough so that...

the v4 is nice! cant deny that

shell meteor Nov 15, 2023, 4:15 PM

#

tribal flame Next build is gonna be red hopefully

Bros got all the flavors

tribal flame Nov 15, 2023, 8:59 PM

#

@pliant echo I did the motor wires out this time per advice... I don't notice any issues with it going around and under the FC, but for a testing build I want it to affect as little as possible