#Historic mission dialogs
1 messages · Page 1 of 1 (latest)
This sounds like a Current Objective waiting to be completed, and not the timescale (time scale does not influence events in any missions). You can toggle the Current Objective UI to see what it is waiting for.
Part of the challenge in Historic missions is to try and keep up with the mission flow, flight plan and comms. It might take a few tried to understand the flow. You can use the Current Objective to see the current step and see the time of the next event.
Thanks! How can I turn it on? In the other missions the current objective UI is automatically on, but in this one I couldn't find where to activate it
Gave +1 flight-hours to @wind crown (current: #3 - 375)
I think you can toggle it usin [C] or [O], depending on your Input Bindings. You can find it it your input settings.
Thanks that works. By the way another thing, in the P(40) checklist in the apollo missions, at T-10:00, it says to tie the main bus to the batteries, and to verify that the Amps increases and the Volts decreases, but it does the opposite. I don't know if I did something wrong or if it is a problem with the checklist
Gave +1 flight-hours to @wind crown (current: #3 - 376)
I might have written something wrong in the checklist, will need to check what I wrote but I assume that I have made a mistake when writing the checklist from the source.
Sorry that was my fault, i put the selector in main bus instead of bat bus