The LOI burn is not happening as expected, my orientation at the time of burn is 0,0,0 on the FDAIs (in INRTL) but my ORB RATE orientation on FDAI 2 is not retrograde, even after following all the steps for the PREFERRED P52 (doing the preferred alignment before requesting the burn)
I tried redoing the P52 3 minutes before the burn but nothing changed
Is it a bug with the mission or an issue on my end?
#Campaign 4 Mission 3 LOI burn
dreamy quiver
sleek juniper
Was your P52 gimbal angles less than 0.03 degrees?
dreamy quiver
I don't remember, lemme finish this mission and I will check
@sleek juniper in the meantime I remember the FDAIs did move a lot when I did the P52
So might have had big gimbal angles
sleek juniper
If it's more than 0.03, then it's incorrect.
sick wind
Was your P52 gimbal angles less than 0.03 degrees?
thats a star angle limit, not gyro torquing angles
sleek juniper
Ah, my fault