#Container Workload failed to start how to debug check log?

4 messages · Page 1 of 1 (latest)

sharp kindle
#

I have set up a new PC (high end with 64GB RAM 265k) with an RTX 5090. I performed a clean install of Windows 11, and Salad Beta version 1.97 is installed. All whitelisting is configured, virtualization is enabled, and WSL is fully updated. The latest Nvidia driver is also installed.

On this PC, the internal integrated graphics (iGPU) are active and the monitor is connected to them in order to free up the maximum performance of the RTX 5090 for workloads. Salad downloaded a container overnight but was unable to start it. It gives a 'Container workload failed to start contact supplier' error.

Is there a way to debug this or are there log files to see exactly what is causing this? The system is a clean install, runs stably, and was benchmarked beforehand. Internet speed 1Gbit down/500Mbit upload.

raw owl
#

Same issue here with 5090 and 9950X3D 192gb of ddr5.

It was running fine before, not sure when it started happening but I can't run any job

idle swan
coral crater