Quick sum: I’m stalling on the rebound when I’m in gear. Whenever I’m in neutral it is fine. Lil example story: I start the car and it idles fine I have it turned up to 1100 rpm’s on my tune for the reason I’m about to explain. Anyways, I put it into first and it wants to stall. I can drive in gear fine I even did a 3rd gear 2k rpm to redline pull to make sure there’s no loss of performance and itll run butter smooth but then when I come to a stop in gear clutch in, it’ll stall. I can’t figure out why I’ve taken my AVCS solenoid out made sure they work by connecting them directly to the batter and cleaned them. I’ve also changed the oil for good measure to see if it was just bad oil but nope nothing. I can’t seem to figure out what’s going in as it doesn’t make sense to me. I have gotten codes such as p0011 p0021 p2093 and p2089. I’m going to buy a multi meter rn to see if it is a grounding issue but what else could it be?
#Idle not bouncing back
noble coral
The car has been sitting for a while and I recently just got it on the road. I had to replace the fuel injectors and the when I did the car ran fine for about a month before this issue just appeared I had no signs it was eventually going to happen
rotund coyote
no o2 sensor codes yet?
noble coral
no o2 sensor codes yet?
nope just cam gears
rotund coyote
dunno, your setup is beyond that little bit of knowledge I have
winter wedge
Quick sum: I’m stalling on the rebound when I’m in gear. Whenever I’m in neutral...
Does it do it more hot than cold or does it do it on cold start too?
noble coral
Does it do it more hot than cold or does it do it on cold start too?
it doesnt matter if its cold or hot
itll start and idle perfectly fine its just when i move it and push the clutch in it wont hold idle
winter wedge
How's the vacuum
noble coral
i dont have a vacuum smoke tester thingy
winter wedge
i dont have a vacuum smoke tester thingy
Get a vacuum gauge