I'm running into a persistent issue where my main MCU (mcu) crashes with a Lost communication with MCU 'mcu' error the moment I try to heat up my extruder (e.g., during PID_CALIBRATE or SET_HEATER_TEMPERATURE).
Printer: Voron 2.4 (48V AWD )
Mainboard: BTT Manta M8P V2
Toolhead: BTT EBB SB2209 USB
Firmware: Kalico
#Help diagnosing main MCU crash (Lost communication with MCU 'mcu') during extruder heating (BTT EBB
upper orbit
slow phoenix
I'm running into a persistent issue where my main MCU (mcu) crashes with a Lost ...
This heavily sounds like a short on the heater
upper orbit
This heavily sounds like a short on the heater
I will double check
What's weird If I run pid tune it runs for 10- 20 seconds, but If I turn on the heater manually it disconnects after 2 seconds
So I didn't assume there's a shot coz it's working
Do I check the heater cable to the toolhead board or the heater itself