#Can someone check my Formbot Voron 2.4 Pro+ 350mm 3MF before I print?

1 messages · Page 1 of 1 (latest)

lapis stag
#

Hi! I’m building a Formbot Voron 2.4 Pro+ 350mm with Dragon HF, TAP and CAN. I’ve organized all the printed parts into a Bambu Studio 3MF.

Could someone please check that I have all the required parts and quantities, that the print orientations are correct, and that I haven’t included any wrong or duplicate parts? Also, can I print these parts with a 0.6mm nozzle, or should I stick with 0.4mm?

If checking the whole 3MF is too much, could someone point me to where I can verify that my parts list, quantities, and orientations are correct for this specific Formbot kit?

📎 FB2.4R2build.3mf
quaint orbit
lapis stag
#

I went through the configurator, but my kit uses a BTT Manta M8P + CB1, which isn't listed as an MCU option. I’m also using TAP, CAN, and a Dragon HF, so some Formbot parts differ from the standard ones.
Also, should I print the STLs in their default imported orientation, even if they look strange, or rotate them to what I think is best? Is there somewhere I can verify the correct orientations, especially for the TAP parts?

quaint orbit
#

All official voron parts are saved in their intended orientation for printing without supports.

#

If supports are necessary they are built into the file eg for tap and stealthburner

lapis stag
#

Do you know if this is also true for the Formbot-specific STL files? Can I assume those are already saved in their intended print orientation as well?

quaint orbit
#

They should be. Do you have an example of some parts that gave you concern.

lapis stag
#

these 4 parts are the ones that confused me

image.png
quaint orbit
#

Ok those are not correct

lapis stag
#

yea

#

i think its because i downloaded the files from formbot and not from the voron website

quaint orbit
#

For tap and the formbot kit you should be able to use the STLs from voron for tap r8 without issues.