waxen trout
I have been noticing some sideways bulging on my print when it is printing the first layer. I have attached an Image to show what it looks like. What could be the issue? It seems to be one of the reasons I am not getting a good large first layer (300x300). Small prints have been coming out fine so far. On the large print I have been trying, after a while of printing the first layer like 20% of first layer, the first layer comes off from the build plate. I am also using a 7 x 7 Bed mesh.
royal vine
this is just my opinion here, but you either need to lift the Z a tiny bit - maybe 0.1... or change first layer extrusion down a bit. #slicers_and_print_help might be an option for asking what they think too...
waxen trout
this is just my opinion here, but you either need to lift the Z a tiny bit - may...
Thank you. Will try out raising my Z-offset.
mortal surge
https://ellis3dp.com/Print-Tuning-Guide/articles/first_layer_squish.html
a guide to help get a better first layer
royal vine
fix it?