X axis is a little wonky

[celest pilot]

Voron 2.4 350
Beacon
Galvanic
24v LDO motors

Printing voron cube now

[celest pilot]

the printer prints pretty good in my opinion, however i would like to be vetted for PiF to provide parts to the community

[glacial helm]

👋

[celest pilot]

😁

[glacial helm]

please ping me once u feel comfortable everything of the "how to post here" is provided 🙂

no rush, take your time

[celest pilot]

i think i have provided everything the rules ask for. please let me know if you need anything else

[glacial helm]

do you ***think *** or did u verify?

[celest pilot]

im pretty sure lol

[glacial helm]

that doesnt answer my question 🙂

[celest pilot]

yes i verified

[glacial helm]

great.

Yellow is not good to see ringing. non shining black is preferred.

[glacial helm]

but before we get started i would like to set expectations accordingly.

so please make yourself very aware of the channels name, #1308016330326413393 , "basic help". we wont get u to PiF here, for that we have a different channel. 🙂
however, we will try to get X to look better

[celest pilot]

i understand

[glacial helm]

which ADXL was used?

[celest pilot]

just the first of many steps to get there

i am using beacon ADXL

[glacial helm]

do u have a Toolhead board with one built in?
if yes, please use that one for another run

[celest pilot]

i have the nh36 on the jabberwocky. i will have to check the docs

[glacial helm]

u also want to adjust your XY joints according to the attached image 🙂
especially the right one, but best to check all screws

[celest pilot]

ok

Left blue i made finger tight. I cannot make it flush. Everything else is as described

running graphs on toolhead adxl

[glacial helm]

That looks better 👍

[celest pilot]

new graphs from toolhead adxl

i am going to print new voron cube in polymaker black abs

[glacial helm]

Looks way better

Update your config with these fresh values, make sure to add damping_ratio as well

Then print a cube with ideally black matte filament at the lower accel recommendation u got, a little below that (-200 or -400)

Use mzv for x and y

Im curious how x will look with 3% left

[celest pilot]

I updated the input shaper settings but not accel. I guess I should stop this print and update accel and reprint

Should I make all accel setting in slicer the lowest y value?

Or just change max_accel in printer.cfg?

i went ahead and changed slicer and max_accel in printer.cfg

[celest pilot]

Ringing seems to be non existent.

Or very low to my untrained eye

This is from a while ago when I first tuned input shaper

[silver folio]

You got a little on y

I think it might be your umbilical setup