Sensorless Homing settings | VORONDesign | Page 1

obtuse steppe Feb 17, 2026, 10:29 PM

#

So when I turn my printer on and do home all and the tool head is in a random location from when I turned it off its doesn't home correctly.
So I find if I put the tool head in the center of the bed then do a home all it will home ok.
Is there a command in print_end to center the head before starting a new print or from power on .

twilit wing Feb 17, 2026, 10:50 PM

#

obtuse steppe So when I turn my printer on and do home all and the tool head is in a random lo...

moving the toolhead to the centre of the bed at print end is just putting a bandaid over the real issue, imo

we should address the root cause instead

can you post a video of when the printer doesn't home correctly?

btw, i think the title should be "sensorless homing settings" 😉

obtuse steppe Feb 17, 2026, 11:37 PM

#

Yes i agree on both.

#

Sensorless Homing settings

#

Here it is.

📎 klippy_29.log

obtuse steppe Feb 18, 2026, 2:22 AM

#

Here is moving it to center by hand .

obtuse steppe Feb 18, 2026, 9:35 PM

#

Any ideas on what I got set wrong?

obtuse steppe Feb 19, 2026, 6:47 PM

#

I will run through the voron setup for sensorless homing again , must have missed something. Done it like 4 times.

#Sensorless Homing settings