300mm Siboor Trident CNC AWD

[crude owl]

I should note, I have manually sync'd the motors at my current tension and I am running the motor-sync plugin before any input shaper testing

[solar sky]

I think it is your umbilical routing

This is how my trident 350 umbilical is routed

Try taking off the plastic umbilical guide

[crude owl]

I assume you are talking about the PTFE guide I have. If so that is a recent addition. I can remove it and retest but I did have these funky graphs before adding that guide.

[solar sky]

if you are getting good prints, how much do you want to investigate. Cause the investigation may cause you to start getting bad prints

[light dagger]

this is exactly what i thought

[crude owl]

Yes it does print amazing without any quality issues, if you do not think there is anything worth me looking into then I will leave well enough alone.

[solar sky]

I would leave well enough alone

testing and troubleshooting this may cause it to print not so good

[crude owl]

Kind of like my 2.4 I have, It has beautiful graphs but has never printed right.
I appreciate the feedback.

[light dagger]

as we all agree, i will mark this post as SOLVED and close it