warm edge
I ran out of ideas. I am printing ASA not for the first time, it has always been working nicely. Now after two layers, the Hotend clogs. Every single time, and the nozzle shows strings over and over.
Does anyone recognize this and can give advice how to solve it?
raven gust
I ran out of ideas. I am printing ASA not for the first time, it has always been...
can you confirm that the hotend fan is on @ 100%
warm edge
can you confirm that the hotend fan is on @ 100%
Yes I can, checked Fans after first clogging
raven gust
Yes I can, checked Fans after first clogging
have you dried the filament?
warm edge
It's a Stealthburner, maybe it just resists printing the A4T
warm edge
have you dried the filament?
No, it has been working like this for a month now
raven gust
No, it has been working like this for a month now
do you have a filament dryer?
warm edge
I have a simple IKEA samla drybox, might take a while to dry it
raven gust
I have a simple IKEA samla drybox, might take a while to dry it
yes, it would
when it clogs, are you able to manually push filament thru?
check that the extruder gears are clean
warm edge
I will disassemble the Toolhead today and look into the details.
raven gust
I will disassemble the Toolhead today and look into the details.
no need to disassemble, just open the latch to take a look
warm edge
no need to disassemble, just open the latch to take a look
Can't, because of Filametrix 😄
raven gust
Can't, because of Filametrix 😄
oh, well, ok