Disaster belts

[remote otter]

Was at 99% last month

checked belt tesion at 150mm both sides set 2.1 for belt tension

[ember slate]

Have u seen https://youtu.be/-fKI9xY3LLI?si=YLg8ar-DO9Cp3fCY ?

If not, you know what to do 😉

[remote otter]

Soemthing wrong with X

[ember slate]

are u just trying to get belt graph accurate? because thats the title of this post basically

trying to see whats going on here and what our task is

[ember slate]

are u there? 🙂 Could u kindly answer my question please

[remote otter]

Sorry was at work today yes I was just trying to get rid of the X ( 2 ) peak and get the green for better graphs

[ember slate]

get rid of the X ( 2 )
this? see image

and green = belt graph?

[remote otter]

Corrrect

[ember slate]

ok so u want more than JUST belt graph 🙂

[remote otter]

My Y axis looks alot better

[ember slate]

then i kindly ask you to review the guidelines for posting here and post everything mentioned accordingly

[ember slate]

to get an idea of what your post should look like, u can click on these 2 "unknown" posts - just click on them, they will load 😉

[cursive citrus]

@remote otter can you please provide a picture of the front, left, and right sides of your toolhead please

[remote otter]

@reth

[cursive citrus]

what x-carriage are you using

[remote otter]

Jabberwocky mount with 2 belted screws

Looks like there is a new mount for the mgn12h_x mount block

[cursive citrus]

@dusty glacier did you have a similar issue?

[dusty glacier]

Yup I worked with Terrance to design a better mount to hold the belt tension

[cursive citrus]

Do you have said mount

[dusty glacier]

It’s 3.0 pretension

[remote otter]

Which block. I see a split mount 6mm

I give that a try split mount 6mm

[dusty glacier]

@daring crag

[dusty glacier]

Not sure if the new ones have been uploaded publicly yet

[remote otter]

Ok I'll wait then

[daring crag]

yes they have been updated yesterday

I tested both the 9mm and 6mm with weights. The 6mm version held up to 50kg and didn't go any higher than that, and the 9mm is a different design, but held up to 40kg of weight. Both should be much better than previous designs that put too much pressure on the Carriage bearing caps.

[remote otter]

Link please so I get the correct one for 6mm and thank you

[daring crag]

https://github.com/kinematicdigit/Jabberwocky/tree/main/Development-testing/V82-RC4/4. Voron 24 - Trident Mounting/split_mount_6mm_belt

[daring crag]

be aware the new design requres longer belts, so you'll need fresh belts if you had no reserves on your old belts.

[remote otter]

Ok I do have spares