kind island
Hi i have a voron 2.4 rev d inicialy i used the inductive prob, but i had to change to the included klicky duo to temperature drift, well i have done the setup as the github sugested and i got some errors i hope some of you can help with this: the probe is always trigered on the dock and in the toolhead, when i hit hte macro dock probe its says its already docked, im confused with this because there connection to the wires in the nitehawk from the micro switch.
maiden lake
Hello, try doing query_probe with:
Probe attached
Probe in your hand
Probe attached and the switch pin pressed
Give an update on each test
kind island
always triggered Ç_Ç
olive dove
always triggered Ç_Ç
what pin do you have defined for the klicky?
maiden lake
That's the issue probably
kind island
if i switch to ! before nhk it stays open all the time
maiden lake
Can you change it to an endstop pin
kind island
how so?
maiden lake
Because the probe pins normally have extra hardware to allow the probe to use 24/12v signals and that does not work with a switch normally
kind island
right but i cant change the port on the nt hawk physicly, does that detail matther?
kind island
i can try to find it
i now that is this one https://github.com/MotorDynamicsLab/Nitehawk-SB
i added the ^before the pin and dint fix anything
the the connecotr port is the correct one
so update i was able to dock the probe but not atach it, i added the ^! before the pin name but i keep getting this errors
maiden lake
Did you connect to GPIO10
