I can't seem to save the z offset I want, is there something that overwrites it?
V2 with Cartographer and virtual stop end, I adjust to the correct value and use SAVE_CONFIG, but it does not save it?
#saving z offset
livid ginkgo
worn turtle
You have to save the new offset before do the save_config
You also can’t have an offset below the bed.
livid ginkgo
Sorry I meant to say I use Z_OFFSET_APPLY_PROBE first, is that not right
Probably not related but I seem to lose z offset as thr print goes along, I can get the first layer pretty nice looking, but the final top surface always looks like the nozzle is too low
worn turtle
You say it doesn’t save it, how do you know it doesn’t?
worn turtle
Probably not related but I seem to lose z offset as thr print goes along, I can ...
You don’t lose tye offset, it’s probably over extruded on the top surface.
livid ginkgo
You say it doesn’t save it, how do you know it doesn’t?
The nozzle is too close to the bed again after a reset, if I add .16 it goes back to good again
worn turtle
But have you checked the config actually updates or doesn’t update?
livid ginkgo
You don’t lose tye offset, it’s probably over extruded on the top surface.
Yeah, I just dont get how I can be just off "too high" on the first few layers but not on yhr top layer, is there a final layer flowrate?
livid ginkgo
But have you checked the config actually updates or doesn’t update?
Embarassingly, im not 100% sure where to look
worn turtle
Are you using Touch or not? What version Cartographer is it?
upload your printer.cfg
livid ginkgo
V1.2.3 i updated everything before the last attempt
worn turtle
Doesn’t answer my questions. And that sounds like the old plugin.
livid ginkgo
Doesn’t answer my questions. And that sounds like the old plugin.
Sorry I thought you meant the software version
worn turtle
It’s helpful to know because it sounds like the old plugin but i need the other info.
worn turtle
Right so looks like your config needs a few changes. I'm going give you a link, check you have your config match what’s asked for.
I would also suggest, once you have corrected your config including start print macro, you delete your current calibration from the bottom of your config and calibrate again.