Print.cfg advice needed on new settings after bed move

[visual fern]

HI, I have just installed a brush for cleaning the nozzle. I had to move the bed forward so the nozzle would go over the brush. I saw a lot of posts which gave advice regarding this. but no advice what I should change exactly in my print.cfg. i have had to move the bed forward about 9mms. so now the edge of the bed reads at Y341. What should i change and where in the print.cfg. is it the Y stepper position_endstop: 350
position_max: 350
Should i now add the 9mms to these setting? no idea lol. many thanks in advance

[fiery lantern]

have you followed define 0,0 point ?

[visual fern]

I did on the initial set up. ill have another look. 🙂

[fiery lantern]

it should have everything you need to adjust your 0,0 point