Axes twist?

[pine heron]

No matter what mesh I make or what adjustments I make, the left side always ends up lower than the right side, as seen in the image.
While searching for information, I found this article:
https://docs.vorondesign.com/community/troubleshooting/badnoob/rail_misalignment_causing_twist.html

I think it fits my problem, but I can't find the tool to make the adjustment. I also notice that the post is a bit old.

Is there another way to make this adjustment?
Do you know of any other guides?

Thanks.

[floral vector]

Axis twist compensation is built in Klipper now.

[pine heron]

i have a clicky probe, and is not compatible with dockable probe i read.

[placid coyote]

Should be. I use kalico dockable probe with a klicky-00 on one machine

[pine heron]

And how is the procedure done? Could you give me some guidance?

[placid coyote]

It's remarkably easy to setup. I think there's a little bit of a guide somewhere in the kalico docs. But you just kinda work out a couple of sets of dock coordinates (starting position attach position, etc) plug em in....and it just works

It's actually much easier to setup than klicky macros, from what I recall

(It's been a while though)

[pine heron]

Thank you very much. I'll look for the documentation you mentioned. I'm very grateful for the help.

[placid coyote]

If you run into any specific issue, let me know, and I'll try to remember what I did 😛