X-Axis wants out

[molten patio]

I belive this is the culprit but I am unsure

[thorn kettle]

👋

Please ping me or reply to this message, once u are comfortable everything in the guidelines is provided by u

[thorn kettle]

FYI those are the Machine limits. We only care about the slice setting accelerations 🙂

[molten patio]

is a benchy instead of cube ok?

[thorn kettle]

No, we prefer the cube with the exact slicer settings mentioned please

[molten patio]

is it ok if printed with gf abs?

[thorn kettle]

Gf/cf blend ringing away, so no.

[molten patio]

ok

i dont get ringing in my print just want to clean the graph up

[cold ether]

can you run belts and input shaper with sweeping turned off please

[molten patio]

sweeping is not specified in my printer and it does it anyways idk how to turn it off tbh

[cold ether]

[resonance_tester]
accel_chip: adxl345
probe_points:
175, 175, 20
accel_per_hz: 100
sweeping_accel: 400
sweeping_period: 0

[thorn kettle]

Did u click on that?🙂

[molten patio]

yes

[molten patio]

should i just restart this thread

[thorn kettle]

That will bring u to the needed config section
i.e. what reth posted above for you kindly

[thorn kettle]

That would be appreciated, yes.

Before creating the post make sure u have everything thats in the guidelines.
Also have a VERY close look at the 2 example posts, so u know what yours should look like 👍