#New klipper install crashes after adding cfg files

28 messages · Page 1 of 1 (latest)

dreamy wharf
#

Hey guys

A few weeks ago I run into a disconnect problem which moonraker.
I have Been pulling my hair since that day.
I saw that my Sd card had a bad Section
So I switched to another good sd card.
I reinstalld mainsail os on my pi 3b+
And added my working cfg files back and klipper craches. After a power of reboot ( pulling the plug) klipper start of where the last eror ( That I created ) was.

I'm stuck now and dont know wat to do next.

rapid oxide
#

You should rename your config file printer.cfg

#

Otherwise it will not working

#

FileNotFoundError: [Errno 2] No such file or directory: '/home/pi/printer_data/config/printer.cfg

dreamy wharf
#

Rename to what Actually?
This is da last eror i get and then my pi dus noting

#

This event is not logt and noting is working

dreamy wharf
rose mantle
dreamy wharf
#

I added the 1 ass a test klipper runs now bud if i delete tha 1 it lucks op

rose mantle
rapid oxide
#

printer.cfg or nothing else 🙂

dreamy wharf
#

And pi lockt up

#

Lets start over rhis are the files that workt and now They Don.
't

#

When the pi locks up ssh and winscp do not conect

rose mantle
#

Have you tried connecting to the IP address rather than hostname?

dreamy wharf
#

Even with the ip add i can not connect to my pi when it locks up

rose mantle
#

Then I would suggest either try reinstalling mainsail again and try to avoid just pulling the plug

Or your pi itself might have issues.

dreamy wharf
#

If i dont pul the plug the pi Does nothing

#

Reinstalling mainsail os now

#

Even if i follow the kiauh instruction i have the same Issu.

By the way sorry for the bad English

rapid oxide
#

Did you take a look into your moonraker.log ?

dreamy wharf
rapid oxide
dreamy wharf