I have setup my formbot voron 2.4 R2 pro+ with m8p + cb1 and sb2209 can. I have added my .config files. When running klipper, all motor test works (STEPPER_BUZZ STEPPER=stepper_x), heater and temerature works, lights and leds works, endstops work as intented, inlcuding tap (QUERY_ENDSTOPS). When homing X or Y, the front 2 Z Moters (Motor Z0 (Motor 3A) and Motor Z3 (Motor 6)) move up and the back Z motors do not move, making the gantry racked. Then the Y homing continues as expected. Is there something wrong with my klipper config files, or would this be a fysical problem (Belt tensioning, etc.). FYI: I have the formbot 300x300 kit and I have turned the Z0 (Front left Z motor 90 degrees as mention by this guide).
#X and Y Homing Moves front 2 Z motors making the gantry racked (Formbot 2.4 R2 Pro+ M8P)
barren junco
X and Y Homing Moves front 2 Z motors making the gantry racked (Formbot 2.4 R2 Pro+ M8P)
This might be a direction problem? My motors are coreclty wires as in the comments of my .cfg files, i have tested this with motor buzz test
opal thorn
Are you sure you did the full buzz tests, as shown in the startup guide?
(Which explicitly calls out which direction each motor should buzz. Not just that it buzzes)
barren junco
No, it was a direction problem. It is fixed now, hopfully my voron gantry has not taking to much dmg from being racked by this
Thx again
opal thorn
No, it was a direction problem. It is fixed now, hopfully my voron gantry has no...
It shouldn't. Bashing into the bed full force can do some harm, but most of the time what you did there will just flex the plastic joints a bit, which is fine
barren junco
It shouldn't. Bashing into the bed full force can do some harm, but most of th...
Should crashing the toolhead into the bed be possible if my tap endstop is working as intended also quad grantry leveling works
opal thorn
Should crashing the toolhead into the bed be possible if my tap endstop is worki...
Well, I mean, where there's a will, there's a way