Just finishing up a Voron build. V2 R2 running canbus on a xol toolhead. Going through initial setup using voron guide. Everything checks out. Homing all axis's is good. Using chaotic labs tap BTW. Go to QGL and the z and z3 steppers raise up after first pass visually tilting gantry. By the third pass it is so far tilted that it starts clicking and fails. I have double checked everything. Anybody dealt with similar issue. I'm stumped.
#New Voron build. Initial setup using Voron guide.
hardy latch
marsh grotto
Either your movement axes are wrong, or your z motors are in the wrong order
When you move on the x axis, where is x=0? What about y=0 ?
kindred plank
Just finishing up a Voron build. V2 R2 running canbus on a xol toolhead. Going ...
its been 19 days, do u have an update for us? whats the current state? did u solve it?