narrow sinew
So, I have an issue with the Reverse Bowden on my voron 2.4 that is causing my extruder to jam up.
Right now, it feels like the bowden is adding too much friction to the system. I am running the filament through a side panel to fix the issues.
The PFTE tube has 3mm ID.
sage vine
So, I have an issue with the Reverse Bowden on my voron 2.4 that is causing my e...
Remove the white ptfe retainer, let the ptfe tube flow as it will out the back to the spool. That’s quite a intense bend out the exhaust a 180 into a sweeping 90
narrow sinew
Hey, so even when I remove the PTFE retainer, I have that same bend out the back of the exhaust, and there is no improvement in the issue.
frozen nacelle
Unless the printer is right up against the wall, you should be able to just make a larger-radius bend.
I've also seen some exhaust panel mods that have the tube coming out at an angle.
Here's one I just found, though there are a whole bunch of them:
https://www.printables.com/model/298117-voron-exhaust-filament-side-entry
But usually this is not much of a problem, I've had pretty sharp bends and it has worked just fine for anything except TPU.
narrow sinew
Ya, I dont know why I cant get it to work well. I think I got it working with a 3d printed radius guide that I ziptied the tube to
austere nexus
Ya, I dont know why I cant get it to work well. I think I got it working with a ...
its been 19 days. do u have an update for us? whats the current state? did u solve it?