XY graphs look good.
I would consider this beyond this channels scope, as the name of the channel suggests #1308016330326413393 , we focus on basic help here 🙂
#Micron+ new build
native cobalt
naive karma
XY graphs look good.
I would consider this beyond this channels scope, as the na...
reth told me to make a post here
native cobalt
Well then its in Reth hands
lapis wave
Head over to #unicorn_chasing
However if it prints beautifully you may not want to do anything
@naive karma did I?
Man you are going to get me in trouble with @native cobalt
naive karma
lol so where do you want me to chat at?
lapis wave
run vibrations from 0-600
do you have a high belt tension
what size micron
@lapis notch you ever notice in a micron that the y-accel is faster than the x-accel?
naive karma
180
lapis wave
can you take a few more pictures of the printer focus on the motion parts and one frontal shot
lapis wave
do you xy joint tooth idlers move up and down a bit?
naive karma
no
lapis wave
that may be the reason that x is slower than y
it might be because the plastic is touching the top of the toothed idlers
lapis wave
can you take a front shot and a overhead top shot please
naive karma
lapis notch
<@239626226115936256> you ever notice in a micron that the y-accel is faster tha...
idk
lapis wave
Let’s do the vibration test from 0-600
lapis notch
i dont memorize every microns IS results 
naive karma
Ok I’ll ping you with graph
lapis wave
i dont memorize every microns IS results <a:hehe:880902570003025920>
Can you post some reference graphs please, if you are not busy.
lapis notch
this is my Formbot kit i just built
lapis wave
basically x should be about double y
naive karma
basically x should be about double y
i did increments of 10
also got this message in console
naive karma
carto probe
lapis wave
Do you have a toolhead adxl? If so can you use that please
naive karma
Do you have a toolhead adxl? If so can you use that please
then run everything again?
lapis wave
Yes please
naive karma
Yes please
Its wild how crazy this one looks EBB36
let me tie up some wiring on the tool head. i think those are causing issues
native cobalt
let me tie up some wiring on the tool head. i think those are causing issues
its been 17 days, do u have an update for us? 🙂
naive karma
its been 17 days, do u have an update for us? 🙂
It was the cartographer adxl. I used the ebb36 and it was normal. Weird though. I use my carto on my 350 for IS and I get same results as my ebb36. 🤷
Carto Graph
ebb36
native cobalt
It was the cartographer adxl. I used the ebb36 and it was normal. Weird though....
ok and which graphs give u the best print results?
naive karma
ok and which graphs give u the best print results?
Doesn’t really matter to be honest. I’m printing at 12k acc on everything. It prints beautifully
native cobalt
Doesn’t really matter to be honest. I’m printing at 12k acc on everything. It pr...
ok so we can call this solved?
naive karma
Yea. I though I deleted this post
native cobalt
Yea. I though I deleted this post
no need to delete 🙂 adding the "SOLVED" tag is totally fine. we will close them