slim totem
This is a rebuilt V0.2. Initially I had decent results, but after doing a deracking, I decided to go through the input shaper process again. Doing the belt comparison shows a big difference between A and B even though tension was set to the same frequency for both.
the bulge every 8mm is due to my z lead screw misaligment, which i have since improved
seeing this, I increased tension on belt A by a touch
but it only made it worse. so i did 2 more tests without changing anything
pure breach
What is your goal?
slim totem
What is your goal?
be able to print with consistent quality.
pure breach
There is no resonance on those cubes above.
It appears that what you are seeing is print tuning related
slim totem
There is no resonance on those cubes above.
what about the A/B belt difference? would that cause problems down the line?
pure breach
Print a cube at 45 degrees.
If there is a difference we should see it
slim totem
Print a cube at 45 degrees.
If there is a difference we should see it
right! why didnt i think of that
ok will do and get back tomorrow
pure breach
sounds good
cinder veldt
the bulge every 8mm is due to my z lead screw misaligment, which i have since im...
Bit of resonance there
This is looking super nice vs what you got when you bought it! Make sure belts are equal length
pure breach
I am not sure there is any resonance of that cube. I am not sure what that pattern is, can you take pictures of each side please.
Was the entire cube printed at 45 degrees
slim totem
I am not sure there is any resonance of that cube. I am not sure what that patte...
that one was printed in the standard orientation.
thanks for your help so far! I've decided to put in Tulip mod sooner rather than later so I've put off further resonance tuning until after I've got that done
will be back in a week or two
should I tag this as resolved?