#Can not update MCU 'mcu' config as it is shutdown

1 messages · Page 1 of 1 (latest)

quasi mango
#

Got the following error message

Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Error configuring printer```

Running Manta M8P (CB1) -> PiTBv2 -> SHT36v2. Printer was working fine, then forgot to turn on the stepper fans on an old PiTB so the printer shutdown. When I waited for the steppers to cool and tried to bring the board back up, this error appeared (firmware restart does not help). Replacing the PiTB (to a V2 now) did not help either. Completely lost as to how to start troubleshooting this.
oblique nacelle
#

press firmware restart!

#

(yes, I see where you say it doesn't help)

#

the problem is, your log doesn't include any attempts to reset it that I can find

#

so there's nothing in the log mentioning what the underlying error is

#

we need the log of the attempted reset...

quasi mango
#

Ah sorry! I cleared my very long log and didn't try to firmware restart for the one I uploaded. Correcting that in a sec...

oblique nacelle