I swapped from a CB1 to a CM4, and now i cannot seem to get my config up and running again. It hangs up forever on connecting, then gives me a unable to connect to CM4 error. What am I not doing right?
I've attached my config.
#Unable to Connect to CM4?
narrow cargo
short bolt
I swapped from a CB1 to a CM4, and now i cannot seem to get my config up and run...
2 probable issues:
- Do you have the "linux mcu" installed on the cm4?
- Somehow the serial id for something else (the manta?) has ended up in the [mcu cm4] section
narrow cargo
2 probable issues:
1. Do you have the "linux mcu" installed on the cm4?
2. Some...
-
no..got a guide?
-
I don’t believe so
narrow cargo
2 was a statement of fact
Oh, how do I get the serial? I’m still pretty new to klipper
short bolt
Oh, how do I get the serial? I’m still pretty new to klipper
it's not a real device
it doesn't have a "get the id for the mcu" in the normal sense
you just need to leave it with the original stock setting
which I believe would be /tmp/klipper_host_mcu
narrow cargo
it's not a real device
thank you so much. I've got that part up and running
is there a trick to getting the HDMI7 screen to show klipperscreen?
its showing something from the cm4
short bolt
"hdmi7"?
oh, like the btt one?
normally it's not about the screen
when klipper screen starts, it tends to take over all available displays
so it's typically just about debugging KS, and figuring out why it isn't starting
there's a bunch of info on that subject here:
https://klipperscreen.readthedocs.io/en/latest/Troubleshooting/
narrow cargo
hm