Input Shaper Weird Movement. | VORONDesign | Page 1

warm badger Jan 6, 2025, 9:13 PM

#

I have recently just put new belts on my trident and ran input shaper. The last time i ran input shaper was about 6 months ago. I also recently updated my whole printer in the machine tab. That being said when i ran IS this time the tool head would move in the X and Y directions about 20 mm while its running the test. I dont recall the old method of IS did that. Is this new or did something get changed during the updates? Thanks!

oak quarry Jan 6, 2025, 9:22 PM

#

Hello that is the new sweeping test in klipper.
#1308097646786777108 message

#

see the post above. It is recommended to turn off the sweeping test

warm badger Jan 6, 2025, 9:43 PM

#

Thank you!

warm badger Jan 6, 2025, 9:58 PM

#

@oak quarry So i added that and now im getting a Invalid adxl345 id (got 80 vs e5). error 🤔

oak quarry Jan 6, 2025, 10:36 PM

#

you post your adxl and resonance_testor sections of your printer.cfg

#Input Shaper Weird Movement.