Leviathan v1.2 not showing up

[rugged wadi]

I have a LDO 2.4 rev.D kit. I have been following their software setup guide at https://docs.ldomotors.com/en/voron/voron2/wiring_guide_rev_d. upon getting to the "mainboard firmware setup" and "determining the USB ID of your mainboard and toolboards" section, im inputting "ls dev/serial/by-id" and only the Nitehawk toolboard comes up, not the Leviathan mainboard. I've double checked the leviathan is connected to the RPi and even disconnected the toolboard to make sure the mainboard is the only thing connected. Is there something I'm missing here? Forgive me, but I'm really dumb on the software side of things.

[next hatch]

Have u followed https://ldomotion.com/#/guide/VORON-Leviathan-V12 yet?

If so, at which step are u?

If not, follow it please

[rugged wadi]

sorry, i assumed the board was already set up with the below statement. do i just need to jump to the part about updating klipper firmware?

[next hatch]

Missed that. Try if it shows up via lsusb

[rugged wadi]

This is what i get when i type that in.

[next hatch]

Its also often a power only usb cable

So double and tripe check that your usb cable can indeed transfer data

[next hatch]

Yea its not getting detected at all

[rugged wadi]

ok, swapped the cable and am getting it now. is there a step i should be jumping to on the leviathan guide now?

[next hatch]

There it is 🙂

Run the serial command again now

[rugged wadi]

yeah, still nothing i think?

[next hatch]

Yup not working. I would go through the guide and flash it again. Its also good to have everything on the same klipper version

[rugged wadi]

ok, the manual states to go to https://www.st.com/en/development-tools/stm32cubeprog.html to flash the board. im clicking on the 32bit version. i click download as a guest, then download now, then... nothing happens? am i stupid?

[next hatch]

On which step exactly are u seeing it mentioning the cube programmer

U just need the website i posted above from LDO

With cube programmer A LOT can go wrong

[rugged wadi]

oh, gotcha. ok, thank you.

[rugged wadi]

is it possible the host configuration is already done? I try the CAN routing and it doesn't seem to work. I try the UART routing and it takes me to a new screen with nothing to delete like the guide says.

[next hatch]

The file literally tells u where to look 🙂

[rugged wadi]

sorry, wasn't sure if i should go to that or if it should've been in there regardless.

[rugged wadi]

ok, im at the klipper firmware testing section - validate the interface. for UART, im entering the command
~/katapult-env/bin/python3 ./klippy/console.py /dev/ttyAMA0

and get something similar to the screenshot on the leviathan guide. the last step says to copy /dev/ttyAMA0. am i copying something in this screenshot or am i literally copying that exact text? where am i putting this text if so?

[next hatch]

literally /dev/tty...

[rugged wadi]

ok, well i know that the leviathan is set up correctly now. Im assuming the next step is to get the USB IDs of the mainboard and toolboard? I STILL cannot get one for the leviathan, only the nitehawk toolhead. What am I doing wrong?

[next hatch]

thats correct.
u have the serial ID already, its the AMA0 thing