distant fog
What I'm trying to do is have my extruder heat to 150 degrees prior to and during the bed mesh then, after the bed mesh is complete, heat to the initial layer temp.
My print start macro automatically sets the extruder to the initial layer temp before bed mesh then it has to drop to 150C to complete the mesh and I end up having to clean the ooze before the bed mesh begins. I'm horrible at understanding the code and have experimented with a few things but just get an error most of the time and a lot of frustration. I switched to Orca Slicer and it has more code in there as standard than what I was using in Super Slicer.
I'm not sure what I need to change here but I would like to simplify it?
Attached is both the Orcaslicer Machine Start G-code and Klipper's Print Start Macro.
Any help or suggestions would be appreciated.
verbal cave