Voron 2.4 help

[vapid elm]

Voron 2.4 350
-Xol tool head
-Vitalii AB mounts, CNC carriage, XY joints and idlers.
-Beacon accelerometer
-Galvanic Umbilical holder
-NH36

Question: help eliminating double hump on X

[nocturne stone]

Run input shaper with ebb36

[vapid elm]

I’ll give this a go tomorrow

[vapid elm]

@nocturne stone

[nocturne stone]

I am thinking there is a loose screw in the toolhead/x-axis

The reason I think this is because of the double peak on the main peak in x-axis

Also peak 2 in x-axis could be due to said loose screw if said loose screw was near the carriage.

[vapid elm]

i will go through and take a look. Thanks! these were before i installed the CNC XY joints.

[nocturne stone]

I was going to say peak2 could also be due to mechanical parts

Cnc parts do no damping the freq like plastic parts

What is your belt tension at?

[vapid elm]

just over 2 on a PF makes tool

[nocturne stone]

Try backing it down to 1.8.
Let’s see if the looser belts will absorb the vibrations

[vapid elm]

oops forgot to load filament on the last test. here is with filament loaded and i touched a few screws but nothing was really loose

@nocturne stone this off my beacon.

[nocturne stone]

Take the filament out and retest

Let’s verify it was that

[vapid elm]

@nocturne stone

[nocturne stone]

I am thinking it is more the screws you tightened than filament

[vapid elm]

anything else worth trying or good enough?

[nocturne stone]

Y is your limiting factor you could set x at 3 hump and still be alright

I think this is good enough.
Just note to yourself the screws you adjusted/touched in case you need to say hi to them again

[vapid elm]

kinda my thought as well. Thank you for the help