Adc out if range is not because of placement. Likely just a config issue.
Can you post a screenshot of the error and your klippy.kog file?
#MCU shutdown ADC out of range
sudden ermine
tall flax
Adc out if range is not because of placement. Likely just a config issue.
Can y...
Absolutely, give me just a few and i'll post
sudden ermine
A chamber temp id -50 means it's not plugged into the pin assigned.
What board is it plugged into and can we get a pic of it?
opal spindle
A chamber temp id -50 means it's not plugged into the pin assigned.
What board i...
Interestingly. They have it plugged in and configured to the right port. #1301662866843373639 message
tall flax
Heheheh
Looks like i lied
I accidentally plugged it into the x endstop on the toolhead pcb
sudden ermine
Interestingly. They have it plugged in and configured to the right port. https:/...
Is it plugged in the breakout board correctly? I'd have to check the pins there and can't right now
sudden ermine
I accidentally plugged it into the x endstop on the toolhead pcb
That would do it. 🙂
tall flax
It's always the little oversights that are tripping me up
opal spindle
Is it plugged in the breakout board correctly? I'd have to check the pins there...
Ya know. I don’t see it going to that breakout board. I assumed it was a gantry mount one. Lol.