So i have been using my printer for a while using the bed mesh of the full bed, I switched to adaptive and noticed that when it probes the area where the print is, it doesnt probe the actual spot on the bed where the print gets laid down on. I have a standard stealth burner on my switchwire using an eddy probe in the same place as the induction one would be. Any guidence would be appreciated, as i now wonder if the whole bed mesh didnt work as intended in the first place too.
#Mesh bed level doesnt probe the are where the print actually is
wet pulsar
it would be helpful if you could explain how its off
I do note that your Y offset has the wrong sign though:
a Y offset of -25 is telling klipper that the probe is 25mm IN FRONT of the nozzle. +25 means it's behind the nozzle
regal sparrow
a Y offset of -25 is telling klipper that the probe is 25mm IN FRONT of the nozz...
lets say i print the calibration cube in the center of the bed, once it probes it doesnt probe the center it probes behind where the actual print is on the y axis, the x looks fine though
wet pulsar
lets say i print the calibration cube in the center of the bed, once it probes i...
well, that would be consistent with the sign flip on the offset