Cool concept, runs pwm fans as a heater to maintain specific chamber temps.
However, I'm getting the attached error
#trying to set up fans as heaters.
sterile plank
vapid pawn
@granite solar you did this right?
sterile plank
I got it from wheels the cat but that went to bed. They also use a different print start
I'm not completely stuck on my print start, I just don't like to change too many things at once
granite solar
@sterile plank did you get this from the pins in Marshmallows?
@sterile plank i can help... tomorrow. 🙂 ping me about 9am cst? i know the things to fix but it's late for me
the TLDR is your chamber sensor is gone in favor of the generic heater (which is fine), but your print_start is still referencing the nevermore (which should probably be gone) and waiting for a chamber temp
sterile plank
I am going to test a new change in a bit. However, I will reach out if things aren't sorted
granite solar
@sterile plank definitely around now 🙂
sterile plank
So as if right now, in not able to get my bed up to temp soon enough
Ah I didn't save after my PID tune with fans
sterile plank
Okay, saved.. but getting unknown command again
@granite solar
Why would I not want to enable the nevermore
granite solar
is your nevermore separate from the bedfans?
sterile plank
yes
nevermore is inm the back, my bedfans are 120mm pc fans mounted to the extrusion
im going to switch back heater to sensor as i thought that would do the trick
i guess it is because i am using the thermistor in two places. so i guess i need to either add a thermistor or find a way to use th esame pin twice
let me get the latest of the macro and printer.cfg
im actually heading to teh store for a abotu 30 minutes
granite solar
@sterile plank are your two cfg files above still valid?
sterile plank
@granite solar got it sorted out. sometimes you just need to take a break form gcode and read it later
granite solar
<@676564278978936846> got it sorted out. sometimes you just need to take a break...
sorry i missed the messages. i wasn't checking up on the thread until the ping
sterile plank
np. its all good.