smoky pike
Hello, I almost finished building my voron 2.4r2. I am having issue with home all in klipper. While homing Y,X individually works fine, When I push home all button x homing works but y moves about 10 mm to the left instead of right and starts z homing. Same goes for print start.
I am new to voron please help.
left tendon
Hello, I almost finished building my voron 2.4r2. I am having issue with home al...
Sounds like you've skipped over some of your preflight stuff. Before we even get to the actual homing issue, I think you need to go through the startup stuff again, and make sure that your movement axes are configured correctly, aka, X being left right, and Y being front back
sand riverBOT
left tendon
Once you have that sorted out, make sure you follow the instructions in whichever sensorless homing guide you're following, regarding inserting a pause between the different homing moves, to allow the diag pins time to clear properly
Which sensorless guide are you using?
smoky pike
Sounds like you've skipped over some of your preflight stuff. Before we even ge...
But when home x and y the home correctly.
left tendon
But when home x and y the home correctly.
So Y homes to the back? Because you mentioned it moving to the left /right
Or to look at it another way, when you home x by itself (which I believe you said works), what direction is that movement?
smoky pike
Sorry to the back yes
left tendon
Okay, well, which sensorless guide were you following?
smoky pike
Okay, well, which sensorless guide were you following?
from voron documents as I remember
left tendon
from voron documents as I remember
Are we talking like clee's guide?
Have you setup the macros the way he shows?
smoky pike
Have you setup the macros the way he shows?
No I guess I haven't I just added virtual end stop at endstop_pin: tmc2209_stepper_y:virtual_endstop. Let me go over it. I also use klicky probe. There seems to be a section about it. let me go over it. Thanks for the help