LDO Voron 2.4 r2 C / LDO Leviathan / ----- X/Y motor problems -- Initial build

[copper cave]

Hey all, hoping someone can help with this...
I am having issues getting the X/Y (a/b) motors to respond correctly. They worked fine when I was using the BTT Octopus MCU but now that I have switched to the Leviathan they are not responding correctly when I run the stepper_buzz command or the X/Y home commands. When I run the buzz X command it barely moves, and it looks like it is trying to go forward and left but it almost seems like it is push/pulling against itself if that makes sense?

I have included a few pics and the printer cfg.

Thanks in advance for any help!

Erik

[copper cave]

@wary sable @full viper Any ideas?

[wary sable]

Do your z steppers work?

If so - Have you tried seeing if the problem swaps if you switch the cables

[copper cave]

The most recent thing I have done is pull all the belts and remeasure - make sure they were even and reinstall and validate no racking. Pretty sure I have tried that but I will again

[wary sable]

don't even need belts installed to do stepper buzz

[copper cave]

Oh, yeah sorry - all the Z work as expected.

[copper cave]

Basically does the same thing, with X instead of going diagonal left it goes right. It just barely shifts to the right and forward.

[copper cave]

Whats strange is with the cables swapped when I do the X home it goes left instead of right but Y goes back as expected... Which according to the guide says I should swap the cables... So I swap the cables back and when I try to endstop X and Y. X goes to the left and Y goes foward. Which according to the same guide - say they are inverted and to add or remove an ! - I remove the ! on the enable_pin value and when I try the same command it goes up as expected but doesnt move after and eventually spits out "No trigger on y after full movement".