After udpating klipper i need to reflash MCUs but still same error after that is done | VORONDesign | Page 1

deep moon Mar 3, 2024, 5:29 PM

#

Dont do it via SD card.

#

And that command does not update the pi.

#

See my profile. Then the flashing guide.

pulsar finch Mar 3, 2024, 5:47 PM

#

deep moon Dont do it via SD card.

Can’t do it any other way as far as I know when you have a skr 1.4 turbo. Looking at the pi klipper version it is the same as my current klipper. Still it is outdated?

deep moon Mar 3, 2024, 5:50 PM

#

sure looks like it, for some models yea you will have to go a different route. someone else was just asking about an octo

pulsar finch Mar 3, 2024, 5:55 PM

#

deep moon And that command does not update the pi.

I did follow your guide which clearly states that you will update the pi. Either way how can I fix this. Clearly they are the same but not still needs updating

deep moon Mar 3, 2024, 6:10 PM

#

the rpi is current

#

they match. ignore the dirty part

#

mcu, can and whatever z is, need updated to 0.12.0-115

#After udpating klipper i need to reflash MCUs but still same error after that is done