#Uneven Z axis movement

3 messages · Page 1 of 1 (latest)

west oyster
#

I have a new Voron build with uneven Z axis movement. If I run a QGL and travel the axis up and down, the corners are no longer level. The first layer of a print will come out fine, but after some up and down travel the gantry acts as if it is 'tilted' forwards. I have checked all of the pulleys, grub screws, belt aligned, belt routing, belt tension. Not quite sure what else I should be looking at. This is my 5th build and this has never been an issue.

burnt ferry
#

hmmm wrong pulley?

hollow forge