Home all functions as intended and returns to 175,175. When issuing QUAD_GANTRY_LEVEL the printhead jumps ~25 mm to the right and then attempts to QGL ~25mm offset resulting in the some of the points being off the right off the bed.
#Quad Gantry Level Moving Off Print Bed
hollow condor
dense panther
Sounds like a mechanical problem
Homing moves relatively slowly: only tries to move at 100mm/s at most
By contrast, your qgl is trying to move at 300mm/s, and, based on your description, the motors are skipping
hollow condor
I was having layer shift issues.
So, I tightened belts to ensure the layer shift issues were not belt tension related.
dense panther
Well, sounds like you over tightened
hollow condor
By contrast, your qgl is trying to move at 300mm/s, and, based on your descripti...
I'm genuinely an ape so this is very possible.
dense panther
Just to check, can we see the back of your a/b drives?
dense panther
I'm genuinely an ape so this is very possible.
Ya, the correct belt tension is honestly looser than you think
hollow condor
Just to check, can we see the back of your a/b drives?
I've got my back panel on:/
dense panther
I've got my back panel on:/
Up to you, but it's shockingly common for "it works at low speeds, but not high speeds" to turn out to be the result of belt routing issues at the back
hollow condor
Ya, the correct belt tension is honestly looser than you think
They’re fairly loose now
dense panther
There's a pretty clever belt tension checking tool
