Wiring sanity check | VORONDesign | Page 1

dusky rain Jan 30, 2024, 9:12 AM

#

Hi guys

So i finally finished wiring my ldo kit , however i am running into some issues .

When i plug in the AC inlet sometimes the LED on the Inlet just lights up no matter what i do and the power doesnt go through the rest of the system sometimes it just works ok , i am a bit worried i dont want to continue further to install klipper until i figure this out .

I am attaching some images of my wiring and a video of the issue.

I did the first checkpoint on the LDO guide and this issue was not present

quaint cove Jan 30, 2024, 4:01 PM

#

Does the power get to the power supply or stop at the inlet?

#

I noticed with my LDO kit two of the connectors that plug into the inlet were a little loose and would work their way off over time, try giving them all a light tug and if they come off squeeze them a bit tighter before pushing them back on

#

Wiring job looks fantastic though, nice work.

cosmic perch Jan 30, 2024, 4:40 PM

#

#

Everything matches the wiring guide hmm

dusky rain Jan 30, 2024, 4:45 PM

#

quaint cove I noticed with my LDO kit two of the connectors that plug into the inlet were a ...

Thanks might be this issue , will give it a go tonight

dusky rain Jan 30, 2024, 4:50 PM

#

cosmic perch Everything matches the wiring guide hmm

Yeah i triple checked everything before connecting power , altho my extruder TCM2209 was connected backwards just noticed that

#

Might have blown it up

quaint cove Jan 30, 2024, 4:52 PM

#

Yeah they dont like that

#Wiring sanity check