Z_Calibrate offset not working | VORONDesign | Page 1

lament flax Jan 10, 2024, 7:18 AM

#

Hello, I have Calibrate_Z find the probe offset, but when it starts printing way above the bed. Calibrate_Z is the last thing in my print_start macro. Through the console, it seems that the correct offset is found, but it's just way above the plate as shown when it starts printing. What should I check?

hazy phoenix Jan 10, 2024, 7:50 AM

#

Are you using a mesh? If so, let's get a screenshot of it

lament flax Jan 10, 2024, 8:10 AM

#

Here is one from KAMP print area

#

hazy phoenix Jan 10, 2024, 8:11 AM

#

lament flax

well there's your problem

#

I imagine you're printing about, oh, I don't know... 8.3mm high?

lament flax Jan 10, 2024, 8:11 AM

#

Yeah probably

hazy phoenix Jan 10, 2024, 8:12 AM

#

probably means your mesh config is missing the zero_reference_position setting

lament flax Jan 10, 2024, 8:17 AM

#

hazy phoenix probably means your mesh config is missing the zero_reference_position setting

Just added this to the bed mesh section, will report back

#Z_Calibrate offset not working