odd zenith
Hey all…I’m in the beginning stages of my v2.4 cbt kit from magic phoenix. I have a question in regards to the build plate. I anticipate adding a brush to clean my nuzzle and the bucket that goes with it. Should I alter my build plate location in order to allow for this?
So the manual says 38mm, should I move it to say…28?
Thanks for your time
short bloom
There is still space at the back for a nozzle brush when the bed is 38mm from the front.
odd zenith
There is still space at the back for a nozzle brush when the bed is 38mm from th...
Awesome. Thanks a ton. Do you have a specific build for the nozzle brush that you prefer?
short bloom
I use this one cause it also got a purge bukket https://mods.vorondesign.com/detail/eiGz71BOprk2GapXbQVgA
odd zenith
I use this one cause it also got a purge bukket https://mods.vorondesign.com/det...
Thanks a bunch
mystic rain
You will probably end up shifting the position of your build plate once you power up and determine the range of motion of your nozzle. Don't worry too much about the exact placement of it for now. Just get it close.