octopus V1.1 wiring power. Formbot VS manual

[restive saddle]

In the user Manual it has power jumpers from Motor Power to power. The Formbot kit says jump motor power to bed power. How should I wire it?

Building a Voron 2.4 r2, Formbot pro kit 350mm

[glass flicker]

You just need to link your "power" input to your "motor power". If the kit is not using "bed out" then you do not need a jumper to "bed power". If you are running something from "bed out" then you should add a jumper from "power" or "motor power" to "bed power"

[restive saddle]

My bed is the AC vivedino 650W, plugged into my SSR. So I’d assume it’s not powered by my Octopus v1.1.

Thanks for the help

Old pic, I’ll send a current one later. Hopefully this clears things up

[solid wigeon]

Sorry about that I mean an octopus pro V1.01 there are jumper pins on top of each driver and extra ones all about the board. ill post a picture

[restive saddle]

Yes please send a pic, I see fuses by the power inlets but not jumpers

[restive saddle]

Most current pic:

Bed is connected to “N” and the other 1 on the SSR.

SSR wiring:
1: Bed
2: L
3: DC + -> HE1+
4: DC - -> HE1-

[glass flicker]

OK, that looks ok, but you will need to move your "bed_power" wires over to "power" so your motors will get voltage. Make it match the manual picture you posted

[restive saddle]

Ok will do. Thank you so much

If you see anything else that looks wrong or you recommend should be done differently, please let me know. I’m open to all feedback, this is my first build, it’s been a daunting project

I appreciate the help, thanks!